Shop Etsy

Make a Bling Ring Photo Prop

Apr 4, 2012

by Brittany Watson Jepsen handmade and vintage goods

Looking to create some memorable photos at your wedding? A clever photobooth prop can bring out party fever in your guests. This pair of wedding rings is both humorous and classy. They could be hung from a ceiling or held in hand by guests.


  • White paper 46 x 65 cm or 18.1 inches x 25.6 inches (I used Canson)
  • Mat board 100 x 70 cm or 39.4 inches x 27.6 inches
  • Gold glitter
  • Gold spray paint
  • Spray mount
  • X-acto knife
  • Ruler
  • Cutting board
  • Double-sided tape or glue

To make the origami diamond:

1. Create a square out of your Canson lighter paper by folding over one edge to the other edge of the paper.

2. Cut off the remaining paper with your X-acto.

3. Fold the diagonal. I noted the folds in the paper with pink lines, but it’s not necessary.

4. Fold other diagonal.

5. Fold the lines shown both forward and backward.

6. Fold the paper from one corner to the opposite midpoint.

7. Fold all the lines indicated by the pink lines.

8. Push the sections indicated with the black lines under, making sure that the center is always pushed up from underneath.

9. Squeeze the corners together and gather them in.

10. Glue the insides to one another so it holds the shape.

To make the rings:
1. Cut out the wedding band by cutting out a circle from the mat board with your X-acto. The band is a basic circle 70 cm (27.6 inches) in diameter on the inside. The ring itself is 3.5 cm (1.4 inches) thick.

2. To make the diamond ring, you can use the template, but also blow up the shape and trace around. The circle is still 70 cm in diameter, but it extends up about 19 cm (7.5 inches) from the inside of the ring to the top, and then 15 cm (5.9 inches) wide.

3. Spray paint the band gold. I used an ultra-metallic for a lot of shine.

4. With your spray mount glue, spray the top of the ring and then douse the glue with glitter and trickle it down as you go around the band so it creates an ombre effect.

To put the diamond and ring together:

1. With a pencil, trace the bottom shape of the diamond onto the top part of the wedding ring so that it will fit in nicely.

2. Cut it out with an X-acto.

3. Glue gun the inside of the ring and slide the diamond inside. Hold to secure.


You’re ready to go. Leave out the rings and let your guests go nuts. I’m sure they’ll be the hit of the party!

All photographs by Hilda Grahnat.

More Posts by Brittany | Weddings Category


Sign in to add your own